Step 4 - Install The Receiver - AEI Security & Communications DigiSender ZX7 Mode D'emploi

ENGLISH (EN)
DG458 - DigiSender® ZX7 - Quad Input 5.8GHz Wireless AV Sender

Step 4 - Install the Receiver

The Receiver will pick up the signals being sent by your Transmitter and output them to a connected
TV.
1.
Locate a vacant SCART socket on the back of
your receiving TV and insert the DigiSender®
SCART cable.
3.
Connect the Power Supply Unit (PSU) to the
socket labelled 'POWER' on the Receiver.
Page 08
2.
Ensure that the Audio/Video and Remote Relay
Channel switches on the back of the Receiver
are set to 1.
4.
Connect the Power Supply Unit (PSU) to an
available mains socket and switch on at the back
of the Receiver.
Please read this instruction manual carefully prior to installation