Basic Functions - AEI Security & Communications DigiSender ZX7 Mode D'emploi

ENGLISH (EN)
DG458 - DigiSender® ZX7 - Quad Input 5.8GHz Wireless AV Sender
Using the DigiSender® ZX7

Basic Functions

Turning the DigiSender® ZX7 On and Off
To turn the DigiSender® ZX7 On, press the power button on the front of the Transmitter and Receiver.
The red standby LED will light up green to indicate that the unit is switched on.
To turn the DigiSender® ZX7 Off, press and hold the power button on the front of the Transmitter and
Receiver for approximately 3 seconds.
Alternatively you can turn the units On and Off by pressing the power button on the DigiSender®
Remote Control.
Selecting the Input
To select Input 1 press the power button on the front of the Transmitter once.
Input LED 1 will light up green to indicate that the unit is set to input 1.
To select Input 2 press the power button on the front of the Transmitter a second time.
Input LED 2 will light up green to indicate that the unit is set to input 2.
To select Input 3 press the power button on the front of the Transmitter a third time.
Input LED 3 will light up green to indicate that the unit is set to input 3.
To select Input 4 press the power button on the front of the Transmitter a fourth time.
Input LED 4 will light up green to indicate that the unit is set to input 4.
Alternatively you can select the Input by pressing the button labelled 'Input 1', 'Input 2', 'Input 3' or
'Input 4' on the DigiSender® Remote Control.
Please read this instruction manual carefully prior to installation Page 11