Getting Started - Tivoli Audio PAL+ Manuel Du Propriétaire

English

Getting Started:

1. Extend the antenna.
2. Connect the included power supply to the PAL+ and plug it into a wall outlet.
3. Press the power button on the remote control or briefly press the top control wheel on
the top of the PAL+. Wait for the Auto Scan to finish.
4. Press the Up or Down buttons on the remote control to view available stations and
highlight the station you wish to listen to.
5. Press the Menu/Select button on the remote control to tune the highlighted station.
6. Press the Volume Up or Volume Down buttons on the remote control to adjust the
volume level to your preference, or rotate the top control wheel.
Remote Holder:
A separate holder for the remote control is included.
It incorporates adhesive tape on the backside. Peel
off the backing and apply the holder to either side of
your PAL+ and insert the remote bottom first.
Guide to Features (Top and Front Panels):
1. MULTI-FUNCTION CONTROL WHEEL (TOP):
The control wheel conveniently serves many
functions:
Power: When the PAL+ is off, press the wheel
briefly to power the unit on. When the PAL+ is
on in any source, press and hold the wheel to
power the unit off. (Note: the remote's Power
button will not turn the PAL+ on when the
unit is off and not connected to the external
power supply.)
Volume: When the PAL+ is on in any source,
rotate the wheel clockwise to increase the
volume level and counter-clockwise to de-
crease the volume level.
Tuning: When the PAL+ is on in any source except Aux, press the wheel once and rotate
clockwise to manually tune up and counter-clockwise to manually tune down. Press
again to tune the station and return to the volume function. The letter "T" will show on
the display to indicate manual tuning mode. After about 7 seconds of no activity, the
control wheel will default back to the volume control function.
Source: When the PAL+ is on in any source, press the wheel twice to see the source
menu. Rotate the wheel to the desired source and press to select the source shown.
If a source is not selected within 7 seconds, the display will default back to the last
source used.
8
1 2 3 4 5
1