Alarm Options - Tivoli Audio PAL+ Manuel Du Propriétaire

How to Set the Alarm:
Access the alarm setting either through the main menu or by pressing the alarm
button on the remote.
1. Alarm 1 is shown first. Use the pq and Select buttons to choose between Alarm 1
and Alarm 2. Note: At any point you can navigate through the alarm menu by using
the Back or t buttons, and the Select or u buttons.
2. Use the pq and Select buttons to set the alarm on or off. If the time and date are not
set, the PAL+ will prompt you to set the Time/Date first.
3. Use the pq buttons to set/change the hour, then press Select. Repeat this process
to set/change the minutes, followed by AM/PM (if time is set to 12 hour format), then
press Select.
4. Use the pq buttons to select how long you want the alarm to sound, then press Select.
5. Use the pq buttons to select the source you wish to wake to, then press Select. If you
set the source to DAB (includes DAB+/DMB) or FM, use the pq buttons to select the
station preset or last listened, then press Select. If the alarm source is set to DAB and
the last listened or preset station is unavailable at the time the alarm sounds, the alarm
will default to the tone.
6. Use the pq buttons to set how often the alarm should be set to wake, then press Select.
If "Once" is selected, you must set the date you wish the one time alarm to sound.
7. Lastly, use the pq buttons to set the volume level of the alarm, then press Select.
8. Repeat this process for Alarm 2 if desired.
If you make a mistake at any point in the process, press the Back button on the remote
and begin again.
Your settings will not be saved unless you complete the entire process and the display
shows "Alarm Saved".
IMPORTANT NOTES:
• The alarm cannot sound if the PAL+ is off and not connected to the external adapter.
• The alarm volume will ramp-up over time. It will take several seconds until the
alarm reaches the volume level set in the alarm menu.
• Should power be lost or the battery becomes discharged, the alarm time will be
saved, but the alarm cannot sound without power to the PAL+.

ALARM OPTIONS:

Alarm Quick Set: With the PAL+ in standby, repeatedly press the alarm button briefly to
toggle each alarm on or off.
Alarm Off: To stop the alarm, press the Alarm or Power button on the remote, or press and
hold the Multi-Function Control Wheel on top of the unit.
English
15