Tivoli Audio PAL+ Manuel Du Propriétaire page 12

English
A small clock face [
cancel Sleep, press the Sleep button until the display shows "Off". When operating
on battery-only power (external adapter not plugged-in), if Sleep is engaged and the
alarm is set, after Sleep ends, the alarm will not sound. To use both Sleep and Alarm
features, please be sure the external adapter is connected.
5. SOURCE: Press repeatedly to change sources.
6. INFO: Press repeatedly to cycle through the information available depending on the
source mode. This function does not work in Auxiliary mode.
7. PRESETS 1-5: Press and hold to store the currently tuned station. Press briefly to recall
the station associated with that specific preset. In FM mode, the preset number will be
indicated on the display. There are 5 presets for each band.
8. VOLUME +/–: Press the Volume + button to raise the volume level or the Volume –
button to lower the volume level. If the audio ever sounds distorted, lower the volume
level to avoid damaging the speaker. Adjusting the volume while the PAL+ is muted
will cancel the muting.
9. pq/TUNE +/-: Press to navigate within the menus. Use these same buttons to manually
tune up or down when in FM mode and to auto scan stations. A "T" will show on the
display to indicate manual tuning mode. Press and hold to move quickly through the
frequencies. It will take a second until the frequencies begin to change. Press for 1.5
seconds and release to auto scan to the next station detected. The display will show
"Scanning..." Also refer to "Scan Setting" under the section "Menu and Specific Features".
10. t u: The right arrow button duplicates the Select button. The left arrow button duplicates
the "Back" button in certain menu items.
11. MENU/SELECT: Press and hold to enter the main menu and press briefly to select
items within the menu. For more, see the section marked "Menu".
12. BACK: Press to go back to the previous menu page.
13. MONO: Press to change the Stereo/Mono setting of the Headphone output. The display
will show "M" for mono and "ST" for stereo. "Mono" or "Stereo" will also be one of
the fields shown when pressing the Info button on the remote in FM mode. If you are
listening via headphones to a noisy FM station in stereo, switching to mono may improve
reception. Also see "Balance" under "Menu and Specific Features".
14. BATTERY HOLDER: Remove the protective strip protruding from the battery holder
before using the remote control. Should you ever need to replace the remote's battery,
use Lithium button cell battery model CR2025.
CAUTION: Danger of explosion if the battery is incorrectly replaced. Replace
only with the same or equivalent type. Dispose of spent battery according to your
country's regulations.
12
] will show on the display when the Sleep timer is active. To