Tivoli Audio PAL+ Manuel Du Propriétaire page 10

English
Guide to Features (Rear Panel):
4
3
2
5
1. 12VDC/1000mA: Use this input to operate the PAL+ using its included external power
supply and to charge the battery when the PAL+ is in standby. Use only the power
supply provided with this product. Should the power supply become damaged or
misplaced, use only a like replacement. Any DC adapter used must meet the requirements
of EN/IEC 60065 and be rated at 12VDC 1A and 230V 50Hz (depending on your region's
power requirements). Use of any DC adapter not recommended by the manufacturer/not
meeting this specification may cause a safety hazard. The connector is 5.5mm/2.1mm
center positive. Keep the rubber plug inserted when this input is not in use. It is normal
for the power supply to become warm during use.
2. ANTENNA: Adjust this telescoping antenna and position it for best reception. In strong
FM signal locations, reducing the antenna's length may provide better reception. When
the unit is not in use, keep the antenna retracted to protect it. For more, see the section
marked "Reception".
3. HEADPHONE OUT: Connect a headset (not included) to this variable output for private
listening. Connecting a headset will mute the primary speaker. The headset's volume
is adjusted using the top control wheel and the remote control's volume buttons. Press
the MONO button on the remote to change the Headphone output from Mono to Stereo.
A headphone icon (
is in Stereo. When listening with headphones to an FM station with noise, keeping this
output set to Mono may improve reception. This output accepts a 3.5mm stereo male
mini connector. Avoid using headphones at high volume levels to prevent possible
hearing damage. Do not wear headphones while operating a vehicle. Keep the rubber
plug inserted when this input is not in use.
4. AUX IN: To hear audio from another device, such as an iPod or other MP3 player,
connect said device's audio output to this stereo input and change the source to
Auxiliary using the remote or the top control wheel. This stereo input accepts a 3.5mm
stereo male mini connector. Note: you may need to adjust the volume level differently
10
) will appear on the display to indicate the Headphone output
1