Black & Decker BDEQS15C Mode D'emploi page 6

reMoving & cleaning tHe dust Bag
1. Remove dust bag assembly (3) by rotating the dust bag
assembly approximately 15° counter-clockwise and
pulling it out of the dust chute.
2. Remove the dust bag (3a) from the dust bag support
(3b) by opening the elasticized end of the dust bag (3c)
and sliding it off the dust bag support (fig. B).
3. C arefully shake the dust bag with the elasticized
opening pointing downward to remove the sanding dust.
note: It is best to perform this function outdoors over a trash can to prevent sanding dust
from escaping into the work area.
4. Once the sanding dust is removed from the dust bag, reinstall the dust bag onto the dust
bag support.
5. Reinstall the dust bag assembly into the dust chute as noted above.
installing sandpaper
warning:
Unplug the sander from the power
source before installing or changing the sandpaper.
1. Lift up and outward on the front and rear sandpaper
clamp levers (6) at the front and rear of the backing
pad (7) (fig. c).
2. Insert one end of the ¼ sheet sandpaper (10) with
grit side up into the open front sandpaper clamp (5),
making sure it is aligned with the backing pad. Lift
the sandpaper clamp lever up and inward to lock the
sandpaper into the clamp.
3. W rap the sandpaper sheet around the backing pad and insert it into the open rear
sandpaper clamp (Fig. 4).
note: Make sure the sandpaper is pulled tight over the backing pad for proper sanding operation.
4. L ift the sandpaper clamp lever up and inward to lock the sandpaper into the clamp.
puncHing Holes in sandpaper
The sandpaper must have 8 holes punched in it to allow
the sanding dust to escape from the working surface. The
pattern of these holes must match the hole pattern on
the sanding pad. If the sandpaper you are using does not
have the holes punched, use the hole punch supplied with
the tool to pierce the sandpaper in the correct locations.
1. Install the sandpaper as shown in fig. c.
2. Place the hole punch (9) on a sturdy flat surface (fig. d).
3. Align the corner of the sanding pad (10) with the corner
of the hole punch. This will ensure the holes are punched in the correct location.
4. When the sanding pad is correctly aligned on the hole punch, press the sanding pad firmly
onto the hole punch.
note: The sharp pegs in the hole punch will pierce the sandpaper in the correct location.
warning:
to reduce the risk of injury, let the tool work at its own pace. do
not overload.
warning:
shock hazard. Under no circumstances should this product be used near water.
warning:
Always wear safety goggles or safety glasses with side shields when
operating your sander. Failure to do so could result in foreign objects being thrown into
your eyes resulting in possible serious eye damage.
Always wear an appropriate dust mask and hearing protection when using your sander.
operating instructions
B
3b
C
D
6
3c
3a
6
6