The Remote Control (Optional); Inserting Batteries; Installing The Remote Control Receiver - Medion AKOYA EXTREME X7810 Mode D'emploi

The Remote Control (optional)

This wireless remote control set can only be used to control the Media Center program
on your PC. In order for it to work, the following conditions must be met:
•
The PC must be booted up.
•
Windows® must be fully loaded.
•
The driver software must be installed*.
•
Receiver connected to a USB port.
* All these conditions are met in the delivered state.

Inserting Batteries

1. Turn the remote unit round.
2. Open the battery compartment by pulling off the flap of the cover carefully.
3. Place one-button cell batteries (Type: CR2025, 3V) into the battery compartment.
Ensure that the polarity corresponds to the illustration etched on the inside of the
battery compartment (+ must correspond with + and – with –).
4. Replace the cover of the battery compartment.
Attention!
There will be a danger of explosion if the battery is replaced incorrectly.
Only replace it with the same type or an equivalent type of battery.

Installing the remote control receiver

It does not matter if the notebook is switched on or off when you connect up the remote
control receiver. The necessary driver software is already installed on your computer.
1. Boot up your notebook and wait for Windows
2. Insert the USB plug of the remote control receiver in a free USB slot.
3. Your PC will automatically detect the new device and automatically integrate it
provided that the driver has been installed (delivered state).
*
All these conditions are met in the delivered state.
The Remote Control (optional)
®
to load fully.
57