Danby DPA140HEAUBDB Guide D'utilisation Et D'entretien page 17

Installation Instructions
INSTALLATION IN A DOUBLE-HUNG SASH WINDOW
1. Measure the adhesive foam seal to fi t the windowsill. Then cut the foam seal to the proper length and attach it to the
windowsill. Fig.9
2. Adjust the length of the window slider kit to fi t the width of the window. Open the window sash and place the window
slider kit on the windowsill. Fig.10
3. Cut the foam seal (adhesive type) to the proper length and attach it on the top of the window. Shown in Fig.11
4. Close the window sash securely against the window.
5. Cut the foam seal to an appropriate length and seal the open gap between the top window sash and outer window
sash. Shown in Fig.12.
52 cm - 72 cm - 2.07 m
.
-
28.3 in. 81.5 in
2 m
Windowsill
Window Kit
Windowsill
Foam seal
14
Foam seal A
(adhesive type)
Fig.9
Window Kit
Fig.10
Fig.11
Fig.12