Parts Description - Makita DCU180 Manuel D'instructions

Tape or mask off open contacts and pack up the
battery in such a manner that it cannot move
around in the packaging.
11. Follow your local regulations relating to dis-
posal of battery.
SAVE THESE INSTRUCTIONS.
CAUTION:
Only use genuine Makita batteries.
Use of non-genuine Makita batteries, or batteries that
have been altered, may result in the battery bursting
causing fires, personal injury and damage. It will
also void the Makita warranty for the Makita tool and
charger.
Tips for maintaining maximum
battery life
1. Charge the battery cartridge before completely
discharged. Always stop tool operation and
charge the battery cartridge when you notice
less tool power.
2. Never recharge a fully charged battery car-
tridge. Overcharging shortens the battery
service life.
3. Charge the battery cartridge with room tem-
perature at 10 °C - 40 °C (50 °F - 104 °F). Let
a hot battery cartridge cool down before
charging it.
4. Charge the battery cartridge if you do not use
it for a long period (more than six months).

PARTS DESCRIPTION

Parts description (when the carrier
is installed)
► Fig.1
1 Control panel
3 Switch trigger
5 Brake lever for front
wheel
7 Brake pedal for rear
wheel
9 Front wheel
Parts description (when the bucket
is installed)
► Fig.2
1 Control panel
3 Switch trigger
5 Brake lever for front
wheel
7 Brake pedal for rear
wheel
9 Front wheel
2 Handle
4 Battery box
6 Rear wheel
8 Lamp
10 Carrier
2 Handle
4 Battery box
6 Rear wheel
8 Lamp
10 Bucket
ASSEMBLY
CAUTION:
Always be sure that the machine is
switched off and the battery cartridge is removed
before carrying out any work on the machine.
Assembling main unit
1. Take out the base unit and handles from the box.
► Fig.3
NOTICE:
Be sure to take out the base unit and
handles together, so that excessive force is not
applied to the cords.
2. Place the packing material under the rear side of
the base unit.
► Fig.4: 1. Packing material
3. Insert the rear wheels into the frame.
► Fig.5: 1. Rear wheel
► Fig.6: 1. Rear wheel
NOTE: The support legs can be attached instead of
the rear wheels.
4. Attach the spring washer and the washer to the
short hexagonal bolt, and then tighten them using the
wrench included in the package.
► Fig.7: 1. Short hexagonal bolt 2. Spring washer
3. Washer
► Fig.8
NOTICE:
Be sure to use the short hexagonal
bolts to tighten the rear wheels.
NOTICE:
Fix the rear wheels at the same position
on both sides.
5. Raise the handles, and then insert them into the
base unit.
► Fig.9
NOTICE:
Do not allow the cords inside area "A"
in the figure. Long objects may be entangled with the
cords and cause accidents.
NOTICE:
Do not apply excessive force to the
cords when raising and inserting the handles.
NOTICE:
Be sure to raise the handles with both
hands.
6. Open the carrier frame toward the front.
► Fig.10: 1. Carrier frame
7. Unfold the handles, then insert the long hexagonal
bolts into the base unit, and then tighten the nuts with
the wrench included in the package.
► Fig.11: 1. Long hexagonal bolt
8. Tighten the shoulder bolts from the rear using the
wrench included in the package.
► Fig.12: 1. Shoulder bolt
9. Tighten the short hexagonal bolts from both sides
using the wrench included in the package to fix the
handles.
► Fig.13: 1. Short hexagonal bolt
16 ENGLISH