Makita DCU180 Manuel D'instructions page 15

8. Do not operate the machine on upward slopes
greater than 12°.
If you find an abnormality, stop the machine
9.
on flat ground. Before inspecting the machine,
pull the brake lever and lock the brake, and
then turn the power off.
10. Before operating the machine, make sure that
the lock lever is fully pulled down and com-
pletely locked. If the lock is incomplete, there is a
risk of accident or injury as the carrier or bucket may
be tilted and the objects fall when going downhill.
11. Be careful not to entangle the cords with the
load or obstacles.
Operation on slopes
1. Do not cross on slopes.
Be sure to decrease speed and exercise caution.
2.
3. Exercise caution when starting or stopping the
machine on slopes.
4. As the loads become less stable on slopes,
firmly secure the loads with ropes.
5. As the machine becomes unstable depending on the
condition of the road, keep the load to a minimum.
As the view is obscured on slopes, keep the
6.
height of the load to a minimum.
7. Never park the machine on steep slopes. Park
the machine on flat ground, pull the brake
lever and lock the brake, and then turn the
power off.
Do not change the direction or speed mode on
8.
steep slopes.
9. Do not release the switch trigger on upward
slopes. The machine may go in reverse and
cause an accident.
10. Make sure that the remaining battery capacity
is enough before operating on slopes. If the
remaining battery capacity is not enough, charge
the battery or replace it with a charged one.
Loading objects
Do not overload objects. When loading
1.
objects, be sure to follow the instructions and
load limits in the manual.
Firmly secure the objects with ropes.
2.
3. Load the objects within the carrier or bucket.
If the objects protrude from the carrier or bucket,
there is a risk of accidents due to the objects
falling or contact obstacles such as walls.
4. Be sure that loaded objects are below eye
level. If the load is too high, it is dangerous
because the view is obscured. Also, there is a risk
of overturning and injury because the load is likely
to be unbalanced.
Load the objects on the carrier or bucket
5.
evenly. If the objects are loaded unevenly, there is
a risk of overturning and injury because the load is
likely to be unbalanced.
6. Before loading the objects or operating the
machine, make sure that the lock lever is fully
pulled down and completely locked.
Be sure to load heavy objects first to keep
7.
balance.
8. Do not extend the front and side rails on steep
slopes. Extend the side rails when lightweight
objects are loaded.
9. When extending the front and side rails, do not
extend them over the extension limit. Be sure to
extend the side rails so that the right and left sides
are the same length, and load objects evenly.
10. Load and unload objects on flat ground.
When lifting and tilting the carrier or bucket,
11.
hold the handles and frame firmly, and work in
a stable posture.
Maintenance
Always be sure to park the machine on flat
1.
ground and lock the brake lever before stor-
age or attempting to perform inspections or
maintenance.
SAVE THESE INSTRUCTIONS.
WARNING:
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product. MISUSE or failure to follow the safety
rules stated in this instruction manual may cause
serious personal injury.
Important safety instructions for
battery cartridge
1. Before using battery cartridge, read all instruc-
tions and cautionary markings on (1) battery
charger, (2) battery, and (3) product using battery.
2. Do not disassemble battery cartridge.
3. If operating time has become excessively
shorter, stop operating immediately. It may
result in a risk of overheating, possible burns
and even an explosion.
4. If electrolyte gets into your eyes, rinse them out
with clear water and seek medical attention right
away. It may result in loss of your eyesight.
5. Do not short the battery cartridge:
(1) Do not touch the terminals with any con-
ductive material.
Avoid storing battery cartridge in a con-
(2)
tainer with other metal objects such as
nails, coins, etc.
Do not expose battery cartridge to water
(3)
or rain.
A battery short can cause a large current flow,
overheating, possible burns and even a breakdown.
6. Do not store the tool and battery cartridge in
locations where the temperature may reach or
exceed 50 °C (122 °F).
Do not incinerate the battery cartridge even if
7.
it is severely damaged or is completely worn
out. The battery cartridge can explode in a fire.
Be careful not to drop or strike battery.
8.
9. Do not use a damaged battery.
10. The contained lithium-ion batteries are subject to
the Dangerous Goods Legislation requirements.
For commercial transports e.g. by third parties,
forwarding agents, special requirement on pack-
aging and labeling must be observed.
For preparation of the item being shipped, consult-
ing an expert for hazardous material is required.
Please also observe possibly more detailed
national regulations.
15 ENGLISH
DO NOT let comfort or familiarity