Fixing The Appliance; Electrical Connection; Important; Start-Up - Vitrifrigo NEXT C330 Serie Manuel D'instructions

75mm from the sides of the appliance may not be observed.
ATTENTION Keep ventilation openings free from obstructions in the recess.
Do not place any objects or other materials near the ventilation grilles, nor cover
or block them.

Fixing the appliance.

To secure the appliance in the recessed area, use the holes on the front base and screws
(see annex 3).

6. ELECTRICAL CONNECTION

ATTENTION:
The operator must be able to disconnect the appliance from the mains electricity.
Make sure that there is an access point to the mains electricity and/or that the plant has
a 6A differential magnetothermal switch with minimum 3 mm opening of the contacts.
Before connecting the product, make sure that the voltage corresponds to that shown
on the identification label or that shown on the label on the compressor.
IMPORTANT: by law, the appliance must be grounded. Make sure that the grounding
system for the electrical network is working perfectly.
We accept no responsibility whatsoever for any injury to people or damage to property
deriving from the failure to properly comply with this regulation.
The use of adaptors, multiple sockets and extension cords is not recommended.
In the event that the appliance's plug and the socket are not compatible, replace the
plug with a suitable one.
This operation must be done by a suitably qualified person who must ensure that the
cable section of the plug is appropriate to the power absorbed by the appliance.
Do not interconnect any other type of appliance to the refrigerator.

7. START-UP

Once the plug is connected to the power outlet, the fridge will start-up automatically in
thermostat mode and no further operations are required for its correct operations.
For a reasonable arrangement and storage of food follow the table below:
ENG
22