Replacing And Reversing The Door; Replacing The Door Panel; Replacing The Led Light Profile - Vitrifrigo NEXT C330 Serie Manuel D'instructions

thickness of more than three millimetres. This operation is necessary in order to guarantee
that the fridge works efficiently and to avoid increasing the electricity consumption. In
order to achieve complete defrosting of the refrigerator turn the thermostat control to
the stop position. Keep the door open so that the defrosting time is quicker.
ATTENTION: Do not use mechanical devices or other means other than those recommended
by the manufacturer to accelerate the defrosting process.
ATTENTION: Do not remove the layer of frost using pointed or sharp metal tools that may
cause a puncture in the cooling plate with irreparable consequences for the appliance.

Replacing and reversing the door

To replace the door, refer to Annex 4; to change its opening direction, refer to Annex 5.

Replacing the door panel

Remove the door following the instructions given in Annex 4, then follow the instructions
in Annex 6.

Replacing the LED light profile

ATTENTION: Replacing the LED light must be done by a suitably qualified person who is
able to adopt all the appropriate safety measures. Before replacing the light, make sure
that the refrigerator is not connected to any electrical supply. If connected, unplug the
appliance from the electrical supply.
1. Remove the protective cover by levering it sideways with a thin-fluted screwdriver (fig.
4).
2. Unscrew the two screws that secure the support containing the LED lights to the light
cover.
ENG
24