Maintenance; In Case Of Technical Problems; Demolition; Warranty - Tecomec JOKER 135 JOLLY Manuel D'instructions

GB
N.B Using a 6mm-thick wheel, expert operators can maintain the original template of the limiter. In this case, it is recommended to
tilt the wheel arm from 10° to 15° (fig. 4). Make sure that this operation is precise, using the template provided (fig. 3 point A)

MAINTENANCE

- Always disconnect the plug from the socket before carrying out any maintenance, lubrication or cleaning operations.
- The machine must be kept clean, in order to make safety instructions and plates clearly legible. Clean it using a rag or a swab.
- Do not use compressed air, that is likely to bring the metal dust in positions which cannot be reached, damaging essential components
of the machine.

IN CASE OF TECHNICAL PROBLEMS

- The machine does not start:
- check that the plug is perfectly connected to the socket
- check that the machine's power cable is not damaged
- check that the socket is energized
- check that no fuses in the socket are broken
- check that the system's automatic circuit breaker has not fused
If, after these operations, the machine cannot start due to a failure, have it checked by an authorized service centre.
- The lamp does not switch on:
- make sure that the lamp is perfectly secured
- make sure that the lamp has not burnt out
If the problem persists, contact an authorized service centre.
- The connection of the machine to the mains trips the automatic circuit breaker:
- contact an authorized service centre.
- The machine's electric motor is overheated:
- check that the voltage indicated on the technical data plate conforms to the line voltage
- check that the motor's cooling fan is running regularly and is not damaged
- check that the grinding wheel does not stop during grinding
If the problem persists, contact an authorized service centre.
- The direction of rotation of the grinding wheel is opposite to the one indicated on the machine:
- contact an authorized service centre
- The machine produces anomalous vibrations:
- check that the machine is properly fastened onto the work bench
- check that the motor is properly fastened to the arm with the three fastening screws
- check that the vice unit is secured to the base by the knob positioned below it
- check that the abrasive wheel is properly assembled on its cantering hub.
If the problem persists, contact an authorized service centre.

DEMOLITION

The grinder type 135 jolly has been fabricated with 90% recyclable materials. Therefore, if the machine must be deactivated, do not
abandon it. Take it to your dealer who will dispose of it correctly.

WARRANTY

- the validity of the warranty on the product is the one recognized in the country of sale. Any request under warranty is valid
if accompanied by a copy of the purchase document (invoice or cash slip). For any repairs, the machine must be sent, free port,
to your dealer.
- The warranty will be void if:
a) the grinder has been tampered with;
b) the grinder has not been used according to this handbook;
c) non-original and/or unauthorized parts, tools, or grinding wheels have been fitted on the machine;
d) the grinder has been connected to voltage values other than the one stated on the serial number plate.
4