Operation - Inventum AKI6015ZWA Manuel D'utilisation

PREPARING THE INSTALLATION OF THE MAINS SOCKET
1. Mark the position for the mains socket.
Place the mains socket inside the kitchen cabinet or just above it.
Make sure you can reach the plug when necessary after installation.
INSTALLING THE APPLIANCE
Preliminary requirements
• Screwdriver
Warning:
Two people are required to install the appliance.
Procedure
1. Place the appliance in the kitchen cabinet.
2. Open the cover of the appliance.
3. Fix the screws (A) to the supports (B) to fasten the appliance to the cabinet. Use the
screwdriver.
4. Place the grease filter.
5. Close the cover.
INSTALLING THE HOSE
1. Install the hose (A) to the appliance (B) and to the exhaust opening (C). Use the hose clamps.
CONNECTING THE APPLIANCE
Caution:
If you wish to make a fixed connection, make sure that there is an omnipolar switch with a minimum
contact separation of 3 mm installed in the supply cable.
1. Make sure that the voltage in your home corresponds with the voltage of the appliance.
2. Use the supplied mains cable to connect the appliance to the mains socket.
5

Operation

STARTING THE APPLIANCE
1. It is advised that you start the appliance a few minutes before you start cooking.
2. Touch the up button to start the appliance. The appliance starts at speed 1 and the display also shows 1.
ADJUSTING THE SPEED
1. Make sure that the appliance is on.
2. Use the up button to increase the speed. The display shows the set speed.
3. Use the down button to decrease the speed. The display shows the set speed.
USING THE BOOSTER MODE
The booster mode provides extra speed to the appliance.
(Figure 7)
(Figure 8)
English • 31