Construction, Layout And Controls - Samlex Solar SCC-30AB Mode D'emploi

5
ConstruCtion, layout & Controls
General
SCC-30AB is designed for flush mounting on a wall / panel. The controls and
indications are built on the Front Panel face plate that has 4 countersunk holes for
flush mounting (Fig. 5.1). All the electronics, DIP switches for settings, terminal strip
for connections for the PV Array and the Battery and terminal for the optional Battery
Temperature Sensor (BTS) are mounted on a PCB that is in turn mounted at the back
of the face plate (Fig. 5.2). For flush mounting on the wall / panel, a suitable cutout is
required to be made in the wall / panel to accommodate the PCB at the back of the
unit. As the components at the back of the unit will be hidden and protected behind
the wall / panel, the components at the back of the unit are exposed and do not have
a protective cover. PLEASE HANDLE THE UNIT CAREFULLy TO PREVENT ANy DAMAGE
TO THE EXPOSED COMPONENTS AT THE BACK OF THE UNIT.
NOTE: As the unit will be connected to 12 V / 24 V Nominal Solar Array / battery system, there is
no likelihood of electrical shock.
Fig. 5.1. Front Panel of SCC-30AB
Fig. 5.2. Back view of SCC-30AB
33