Dismantling/Mounting Yokes/Crosses Of A Wide Angle Joint; Dismantling Yokes/Crosses Of A Wide Angle Joint - WALTERSCHEID SW41 Mode D'emploi

DISMANTLING / MOUNTING YOKES /
CROSSES OF A WIDE ANGLE JOINT
8 Dismantling / mounting yokes / crosses of a wide angle joint
8.1

Dismantling yokes/crosses of a wide angle joint

1. Pull the drive shaft apart.
2. Remove the safety device of the
defective drive shaft half. Observe the
corresponding operating manual of the
drive shaft for this.
3. Lubricate the cross kits.
This minimises the risk of the bearing
®
needles falling out of the bearing
bushes.
4. Insert an appropriate mandrel (1) into
the quick-change system. The diameter
of the mandrel must correspond to the
drill hole diameters of the yokes.
5. Align the position of the mandrel (1)
opposite the bearing bush of the double
yoke.
Observe the operating manual of the drive shaft for the removal
and installation of the safety devices. Download the
corresponding operating manual from our website if necessary.
www.walterscheid.com/en/downloads/manuals/
Always start the dismantling with the bearing bushes of the
double yoke.
Fig. 29
Fig. 30
41