WALTERSCHEID SW41 Mode D'emploi page 100

DISMANTLING / MOUNTING YOKES / CROSSES OF A
WIDE ANGLE JOINT
8.6 Press the cross journal (1) against
the mandrel (2) and operate the
foot switch simultaneously until the
cross kit no longer moves.
The first stage for driving out the
®
second bearing bush is ended.
8.7 Replace the mandrel with the drift
punch (1).
8.8 Turn the double yoke over.
8.9 Press the pivot pin (1) against the
drift punch (2) and operate the foot
switch simultaneously until you can
remove the second bearing bush.
The second stage for driving out
®
the second bearing bush is ended
when you can remove the bearing
bush.
The connecting fork with the cross
®
kit can now be removed from the
double yoke.
44
Fig. 37
Fig. 38
Fig. 39