Product Safety; Safe Operation Of The Special Tool; Safety Devices And Protection Equipment; Structural Changes - WALTERSCHEID SW41 Mode D'emploi

3.3

Product Safety

3.3.1

Safe Operation of the Special Tool

3.3.2

Safety devices and protection equipment

3.3.3

Structural Changes

Only one person is permitted to operate the machine if there
are no persons in the danger zone of the special tool. Observe
the chapter "Danger zone and danger points", page 11.
Only operate the special tool if all safety devices and
•
protective equipment have been installed properly and are
completely functional.
Defective or removed safety devices and protective
equipment can result in dangerous situations.
Check all safety devices and protection equipment for
•
externally recognisable damage and functionality before
you put the special tool into operation.
Structural changes, attachments or conversions to the
•
special tool must only be made with the manufacturer's
written permission.
In the case of non-approved structural changes,
•
attachments or conversions, the declaration of conformity
and the CE marking of the special tool lose their validity.
Only use original parts or conversion and accessory parts
•
approved by the manufacturer so that:
o the declaration of conformity and the CE marking of
the special tool retain their validity,
o the faultless function of the special tool is guaran-
teed.
The manufacturer is not liable for damage caused by:
•
o unauthorised modifications of the special tool,
o non-approved conversion and accessory parts,
o welding and drilling work on load-bearing parts of
the special tool.
19