Delta Q QOOL EVOLUTION Manuel D'utilisation page 12

Fig. 8: Place espresso coffee cup.
Extracting an espresso coffee
• Check whether the water tank is filled with water.
If there is no water in the tank, fill with around 1 L of water
(see Fig. 3).
Note: The maximum capacity of the water tank is 1 L (Max.).
The water tank must be filled up to the maximum level so as to
reduce the frequency of this operation. The machine alerts if
there is not enough water in the tank by means of a luminous
alert message on the control panel buttons.
For further information about the meaning of the alerts and the
luminous alarms, consult the "Alerts and Alarms" chapter (see
Page 22).
Once the water tank has been filled and if it has been removed,
replace it in the initial position and confirm that it has been correctly
fitted (see Fig. 4).
• Connect the electrical plug to an earthed socket.
Switch the On/Off general button which is located at the back
of the equipment.
• The buttons on the control panel will blink in sequence (green
colour) when the equipment starts to pre-heat (approximately
60") (see Fig. 6).
• As soon as the buttons on the control panel stop blinking in
sequence (green colour), the pre-heating is over (see Fig. 7).
• Put an espresso coffee cup on the cup tray under the extraction
nozzle (see Fig. 8).
QOOL
11