Adjusting The Slicing Thickness - KitchenAid KFP1317 Mode D'emploi

PRODUCT ASSEMBLY
INSTALLING THE EXTERNALLY ADJUSTABLE SLICING DISC
1
Hold the Slicing Disc by the finger grips
and lower it onto the Drive Adapter.
TIP:
You may need to adjust the Drive Adapter with a slight turn on the power shaft until
it drops into place. For easiest installation, make sure the Adjustment Knob is in the "0"
position.
3
Once the Work Bowl Cover is closed, the
Lid Latch will lock in position.

ADJUSTING THE SLICING THICKNESS

1
Thinner
Set the desired thickness by moving the
Knob to the left for thinner slices and to
the right for thicker slices.
W11462548A.indb 9 W11462548A.indb 9
2
To attach the Work Bowl Cover, hook the
Lid Hinge into the Handle Hinge on the
Work Bowl and close the Cover.
NOTE: Your Food Processor will not
operate unless the Work Bowl Cover is
fully closed and the Work Bowl is properly
seated on the Base.
NOTE: The Knob only works with
the Externally Adjustable Slicing Disc.
Changing thickness settings with other
discs or Blades installed will have no effect
on operation.
Thicker
9
10/14/2020 12:23:17 PM 10/14/2020 12:23:17 PM