Installing The Adjustable Slicing Disc - KitchenAid KSM1FPA Instructions

INSTALLING THE DISCS
Disc
adapter_
Hold the julienne disc by the 2 finger
3
grips, with the smaller side of the middle
hole facing UP . Install the disc on the disc
adapter by fitting the adapter through
the hole in the bottom of the disc until it
is seated against the liner.

Installing the adjustable slicing disc

Insert the liner into the attachment
1
assembly so that the feed tubes line
up and the liner lies flat.
Set the desired slicing thickness by
3
moving the control lever to the left
for thinner slices or to the right for
thicker slices.
NOTE: If the sliced food is not the desired
thickness, the control lever can be adjusted
during operation.
Finger_ gr_ip
4
2
4
Install the lid by turning counter
clockwise, being sure it locks into place.
Dr_ive pin
Hold the slicing disc by the finger grips
and lower it onto the drive pin. You
may need to turn the disc/drive adapter
until it drops down into place.
Install the lid by turning counter
clockwise, being sure it locks into place.
Finger_ gr_ip
9