Spray Nozzle Selection; Before Operation; Pre-Start Preparation; Hose And Gun Assembly - Excell EPW2123100 Mode D'emploi

SPRAY NOZZLE SELECTION

• SAVE ALL INSTRUCTIONS
Following is information concerning the five
nozzles provided with your pressure washer.
NOTE: The force of the spray on the
surface you are cleaning increases as
you move closer to the surface.
0° High Pressure (Red): The water stream
discharged is very aggressive. Use with
extreme caution to prevent damage to the
surface being cleaned or injury to persons
or animals.
15° High Pressure (Yellow): This is the
nozzle used for most cleaning applications. It
provides narrow coverage and a highly
powerful water stream.

BEFORE OPERATION

• SAVE ALL INSTRUCTIONS
NOTE: The engine and pump on your
EXCELL™ Pressure Washer will often have
improved performance after a break-in
period of several hours.

PRE-START PREPARATION

Before starting the pressure washer, check for
loose or missing parts and for any damage
which may have occurred during shipment.

HOSE AND GUN ASSEMBLY

NOTE: Align threaded connections care-
fully to prevent damaging threads during
assembly. Tighten connections securely
to prevent leaks during operation.
Attach the hose to the inlet of the trigger gun.

LUBRICATION

DO NOT attempt to start the pressure washer
engine without filling the engine crank case
with the proper amount and type of oil. (See
the accompanying engine manual for this
information.) Your pressure washer engine
has been shipped from the factory without oil
in the engine crankcase. Operating the unit
without oil will ruin the engine.
The pump is not equipped with a dipstick or sight
glass windows. Check oil leaks from the pump.
Pump oil is shipped in the pump from factory.
25° High Pressure (Green): Use of this
nozzle offer both a medium coverage and
water stream. Best used for flushing dirt and
debris off surfaces.
40° High Pressure (White): This nozzle is
chemical injector to apply chemicals used for
cleaning with the widest coverage over a
larger area with a powerful water stream.
65° Low Pressure (Black): Provides low
pressure spray and a wide coverage. Used
primarily when operating the chemical injector
to apply chemicals.
FUEL
Fill the tank with clean, fresh unleaded
automotive gasoline. (See Figure 1). Regular
grade gasoline may be used provided a high
octane rating is obtained (at least 85 pump
octane).
W AR NIN G
Serious injury may result from fire caused
by gasoline contacting hot surfaces.
Do not overfill the tank. Keep maximum
fuel level 1/2 inch below the bottom of the
filler neck. This will allow expansion in
hot weather and prevent overflow.
9 - ENG
Copyright © 2017 MAT Industries, LLC
Gasoline is very dangerous.