Intended Use; Warnings And Safety Instructions - Steinbach RX 5 Mode D'emploi

Masquer les pouces Voir aussi pour RX 5:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
Preface
Many thanks for purchasing this Steinbach product. We continually de-
velop and enhance our items, however, should this product be faulty, we
apologise for any inconvenience and politely ask you to get in contact
with our service centre.
Read operating manual and store safely
Instruction manual for Swimming pool cleaner Speedcleaner RX 5
This instruction manual relates to the product stated above. It contains
important information on starting your product for the fi rst time and how
to operate it. Carefully read through the instruction manual - particularly
the safety instructions - before using this product. Non-compliance with
this instruction manual may lead to major injuries or damage to your
product. The instruction manual is based on standards and regulations
applicable within the European Union. If the product is being used ab-
road, please follow any country-specifi c guidelines and laws. Store the
instruction manual in a safe location for later consultation and submissi-
on to third parties, where applicable.

Intended use

This product is solely intended for private use and is not suitable for
commercial use.
Our Speedcleaner RX 5 is an innovative, powerful, automatic pool robot
for cleaning swimming pools. Due to its advanced computer controlled
programming, it can clean both the fl oor and the walls of your swimming
pool, without having to empty the pool beforehand. At the same time,
it fi lters the water and removes particles and deposits. As the cleaner
operates with 24 V direct current. it is very safe during operation. Please
read these instructions through thoroughly in order to use it correctly.
Only use the product as described in this instruction manual. Any other
use is considered improper use and may lead to personal injury or
damage to property. This item is not a toy. The manufacturer or retailer
assumes no liability for damage resulting from improper or incorrect
use.

Warnings and safety instructions

Read and observe all instructions. Non-compliance with these
warnings and instructions may result in damage to property,
severe personal injury or even death. These product warnings,
instructions and safety regulations are extensive but cannot cover
all potential risks and dangers and are thus not to be considered
exhaustive. Please be cautious and assess potential dangers
appropriately. Incorrect use/handling of the product can lead to
life-threatening situations.
Caution! Leave repairs to experts in order to prevent hazards.
Consult a specialist workshop. Liability is waived and warranty
claims expire if repairs are carried out independently of if the pro-
duct is improperly installed or used incorrectly. Only original parts
corresponding to the original product specifi cations may be used
during repairs.
WARNING! Hazardous for children and persons with reduced phy-
sical, sensory or mental abilities (such as the handicapped, elderly
individuals with impaired physical and mental abilities), or those
with a lack of experience and knowledge. Children must not be
allowed to play with this product. Cleaning may not be performed
by children and persons with reduced physical, sensory or mental
abilities.
NOTE! Risk of damage! This product may be damaged through
improper use.
Danger of electrocution! Faulty electrical installation or too high
mains voltage can lead to electrocution. Only connect the product
if the mains voltage on the socket corresponds to the technical
specifi cations. Only connect this product using an easily accessib-
le socket to ensure it can be rapidly disconnected from the mains
in the event of a fault. Do not operate the product if it exhibits
visible damage or the mains cable/plug is defective. As additional
protection, it is recommended to install a residual current device
(FI/RCD) with a tripping current of no more than 30 mA. Consult
with an electrician for advice.
Only open the product as described in this manual. Leave repairs
8
to experts in order to prevent hazards. Consult a specialist work-
shop. Liability is waived and warranty claims expire if repairs or
changes to the product are carried out independently of if the pro-
duct is improperly connected or operated incorrectly. This product
features electrical and mechanical parts which are indispensable
for protecting against potential hazards.
Never touch the plug with wet hands. Never pull out the plug from
the socket using the cable - always pull on the plug. Keep the pro-
duct, plug and all cables away from open fi res and hot surfaces.
Lay the cable so that it does not pose a tripping risk and do not
place it under the ground. Lay cables in such a way that they will
not be damaged by lawn mowers and other similar devices. Do not
kink the cable and do not lay it over sharp edges. Do not use an
extension cable, multiple socket adapters or other adapters.
To avoid serious damage to the device, never allow it to operate
outside the water! The device should only be connected to an
earthed 230 V protective contact socket. Nobody may stay in the
pool when the device is in the water. This cleaner is not a toy. For
optimal performance, allow all the air to escape from the device be-
fore turning it on (air bubbles stop coming out of the cleaner, and
it stays on the pool fl oor properly). Do not try to move the fl oats
along the cable. Always leave them in the original position. Before
turning on the cleaner, please ensure the fl oat cable can move
freely to avoid any entanglement. In the worst case, entangle-
ment may lead to damage of the cleaner, and affect the cleaning
effi ciency. After every use, the fi lter holder incl. fi lter bag must be
cleaned immediately. This stops soiled fi lter bags affecting normal
operation of the cleaner. If the cleaner is not being used, it should
be kept in a well ventilated, dark room. Avoid direct sunlight.
During operation, the control box/power supply should be kept
in the shade. The control box/power supply must not be covered,
in order to avoid possible damage and / or overheating. Motors
and other electrical parts must only be opened and repaired by
an expert. Otherwise any claims under guarantee will be rendered
invalid immediately. Only use the cleaner in the operational areas
and under the conditions specifi ed in these instructions.
Caution: Before removing the cleaner from the pool, make sure
that the electricity is fully switched off.
Placement of the power pack
The cleaner's power pack should be place in an appropriate posi-
tion, so that it can reach all the corners and both ends of the pool.
For safety reasons, the power pack should be placed at least 3.5m
from the swimming pool edge. See Fig. 1
Attach the power supply with the included safety line (fi g. 24).
Caution: The power pack should be kept in a shaded are during
operation.
Danger of electrocution! Faulty electrical installation or too high
mains voltage can lead to electrocution. Only connect the product
if the mains voltage on the socket corresponds to the technical
specifi cations. Only connect this product using an easily accessib-
le socket to ensure it can be rapidly disconnected from the mains
in the event of a fault. Do not operate the product if it exhibits
visible damage or the mains cable/plug is defective. As additional
protection, it is recommended to install a residual current device
(FI/RCD) with a tripping current of no more than 30 mA. Consult
with an electrician for advice.
Only open the product as described in this manual. Leave repairs
to experts in order to prevent hazards. Consult a specialist work-
shop. Liability is waived and warranty claims expire if repairs or
changes to the product are carried out independently of if the pro-
duct is improperly connected or operated incorrectly. This product
features electrical and mechanical parts which are indispensable
for protecting against potential hazards.
Never touch the plug with wet hands. Never pull out the plug from
the socket using the cable - always pull on the plug. Keep the pro-
duct, plug and all cables away from open fi res and hot surfaces.
Lay the cable so that it does not pose a tripping risk and do not
place it under the ground. Lay cables in such a way that they will
not be damaged by lawn mowers and other similar devices. Do not
kink the cable and do not lay it over sharp edges. Do not use an
extension cable, multiple socket adapters or other adapters.
To avoid serious damage to the device, never allow it to operate
outside the water! The device should only be connected to an
earthed 230 V protective contact socket. Nobody may stay in the
pool when the device is in the water. This cleaner is not a toy. For
optimal performance, allow all the air to escape from the device be-
061018_v1912
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Speedcleaner rx 5

Table des Matières