Steinbach RX 5 Mode D'emploi page 10

Masquer les pouces Voir aussi pour RX 5:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
Trouble shooting
Fault
Cause
Cable was not relea-
sed properly
The power
cable is
The cable in the water
twisted or
is too long.
tangled.
Cleaner is stuck on
the outlet grille
The power unit is in
the wrong place.
Water circulation in the
pool is switched on.
The cleaner
Connection cable is
cannot reach
too short.
all areas.
Filter bag is blocked.
Algae is growing on
the walls.
Water temperature is
too high / too low.
Cleaner does
not climb up
Brushes are worn
the pool wall.
The cleaner is too
light, it is tilting.
PH value is not
correct.
Power pack is not fully
plugged in.
The cleaner was
Cleaner is
damaged during trans-
not operating.
port.
The operating unit
needs a different vol-
tage to the local one.
Cleaner does
There is air in the
not sink.
cleaner.
Drive roller
Foreign body in the
breaks off.
drive.
Cleaner
Cleaner climbs too
comes up
high, air in the cleaner
Cleaner is
Faulty operation.
faulty.
Important Note
Technical data
■ Input voltage: 220(230) VAC
■ Frequency:: 50 Hz
■ Output voltage: DC (direct current) 24 V
■ Rated power: 200 W
■ Cable length: 18 m
■ Width of cleaning drum: 358 mm
■ max. Cleaning area in swimming pool: 200 m²
■ Filter performance: 15m³/h
■ Filter grade: 200 μm
■ Operating temperature (water): 10°C - 32°C
10
Solutionn
Switch off the unit, release
and uncoil the cable.
Service
Remove the excess cable
from the water.
Please do not send the equipment to us without authorisation, but
please contact our service centre initially!
Switch off the fi lter unit.
If the equipment has to be collected, it must be packed securely and
the invoice (copy) must the enclosed.
Position the power unit so
As soon as the unit reaches us, it will be checked for faults by our
that the cleaner can reach
all areas properly.
claims department, and repaired. On conclusion of this work, your
equipment will be returned to you as quickly as possible.
Switch off the fi lter unit.
If this return is not covered by the guarantee, the costs incurred will
be calculated.
Place the greatest possible
Guarantee processing / guarantees are handled by the company
length of connecting cable
Steinbach VertriebsgmbH.
into the pool, but bear in
The item will be repaired by the company Steinbach VertriebsgmbH,
mind the corresponding
however where no right of return exists it will not be taken back.
minimum distance between
the operating unit and the
Cleaning
pool.
Use conventional cleaning products. Do not use solvent-based or abra-
Replace the fi lter bag.
sive cleaning agents/tools, i.e. no hard sponges, brushes etc..
Clean the pool walls.
Storage
Optimal water temperature
The product must be thoroughly dried after cleaning. After which, it is to
is between 10°C and 32°C.
be stored in a dry location protected from frost.
Contact a dealer, replace
the brushes.
Disposal
Switch the unit off and allow
the air to escape.
Disposing of packaging: The packaging material has been selected
in view of environmental concerns and disposability and is therefore
Test the value to keep it
recyclable. The paper and cardboard can be recycled, as can the plastic
between 7.0 and 7.4.
coverings.
Check the power cable and
Disposing of the product: Applicable in the European Union and other
the operating unit.
European states with systems in place for collecting and sorting recycla-
ble materials. Dispose of the product in accordance with any laws and
Contact a specialist retailer.
regulations applicable at your place of residence.
Warranty conditions
Contact a specialist retailer.
The respective country's legal provisions for warranty conditions shall
apply accordingly. For Austria and Germany, these apply for 2 years
Switch the unit off, allow the
after the date of invoice.
air to escape, and let the
cleaner sink to the bottom.
Declaration of conformity (CE)
Contact a specialist retailer.
The EU declaration of conformity can be requested via the address
shown at the end of this manual.
Switch the unit off, allow the
air to escape.
Symbol explanation
Contact your retailer.
CE: Declaration of Conformity (see "Declaration of Conformity" chapter):
This symbol designates products which fulfi l all applicable community
regulations of the European Economic Area.
■ Crawl speed: 12m/min
■ Hydrolytic resistance class: Cleaner: IPX8; Electricity control box/
power supply: IPX5
■ Surrounding temperature: 10°C - 40°C
■ Weight of the cleaner: 9,5 kg (without cable)
061018_v1912
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Speedcleaner rx 5

Table des Matières