To Program A Preset Time Delay For A Patrol - Dedicated Micros dtx300 Manuel D'utilisation

To Remove a Preset from a Patrol
(1) Select and go to the preset concerned by pressing the appropriate preset button
i.e. button 1 to 8
(2) Press and hold set whilst pressing FOCUS near for Patrol. 1
Press and hold set whilst pressing FOCUS far for Patrol. 2
REMOVE PRESET
FROM PATROL 1
REMOVE PRESET
FROM PATROL 2
To programme a preset time delay for a Patrol
Determine the required time delay from the following table:
Preset button 1 -
Preset button 2 -
Preset button 3 -
Preset button 4 -
Preset button 5 -
Preset button 6 -
Preset button 7 -
Preset button 8 -
Press and release the preset button corresponding with the delay desired, then:-
press and hold set whilst pressing ZOOM out to set Patrol 1.
press and hold set whilst pressing ZOOM in to set Patrol 2.
PRESET TIME DELAY
FOR PATROL 1
PRESET TIME DELAY
FOR PATROL 2
dtx 300, 400, 400d.c. Installation Manual
THEN
UP TO
THEN
UP TO
Random switching from 0 to 1000 seconds
12 Seconds delay
24 Seconds delay
36 Seconds delay
48 Seconds delay
60 Seconds delay
72 Seconds delay
84 Seconds delay
THEN
UP TO
THEN
UP TO
AND
AND
AND
AND
Page. 10