Light Replacement - AEG DD9693-M DD9663-M Instructions De Montage Et Mode D'emploi

Activated charcoal filters (Recirculation Version)
This filter cannot be washed or regenerated, and must be replaced when the Led on Button H
starts to flash, or at least every 4 months. The alarm can only be seen when the Suction motor is
turned on.
Enabling the alarm signal
• For Recirculation Version Hoods, the Filter saturation alarm must be enabled on installation
or at a later date.
• Turn the Lights and the Suction motor off.
• Press button H and hold for at least 5 seconds until the Led gives confirmation as follows:
• Led flashes twice - Activated Charcoal Filter Alarm ENABLED.
• Led flashes once - Activated Charcoal Filter Alarm DISABLED.
Changing the Activated Charcoal Filter
Resetting the alarm signal
• Turn the Lights and the Suction motor off.
• Press button H and hold for at least 2 seconds, confirmation is
provided by the fact that the Led goes out.
Changing the Filter
• Open the glass panel on the hood by pulling downwards.
• Remove the saturated activated charcoal filters as shown (A).
• Fit the new filters, as indicated (B).
• Close the glass panel.
20 W halogen light.
• Extract the lamp from the lamp holder by pulling gently.
• Replace with another of the same type, making sure that the
two pins are properly inserted in the lamp holder socket holes.
EN
Lighting

LIGHT REPLACEMENT

B
A
2
26
6