Philips Wet and dry Shaver S7000 Mode D'emploi page 30

30
English
Problem
The shaver does not
work when I press
the on/off button.
Water is leaking from
the bottom of the
shaver.
Possible cause
Hairs or dirt obstruct
the shaving heads.
The shaver is still
attached to the wall
socket. For safety
reasons, the shaver
can only be used
without cord.
The rechargeable
battery is empty.
The travel lock is
activated.
The shaving unit is
soiled or damaged to
such an extent that
the motor cannot
run.
During cleaning,
water may collect
between the inner
body and the outer
shell of the shaver.
Apple, the Apple logo, iPad, and iPhone are
trademarks of Apple Inc., registered in the U.S. and
other countries. App Store is a service mark of
Apple Inc.
Android is a trademark of Google Inc. Google Play
and the Google Play logo are trademarks of
Google Inc.
Solution
Clean the shaving
heads in the regular
way (see 'Cleaning
the shaver under the
tap') or clean them
thoroughly.
Unplug the shaver
and press the on/off
button to switch on
the shaver.
Charge the battery.
Press the on/off
button for 3 seconds
to deactivate the
travel lock.
Clean the shaving
heads thoroughly or
replace them (see
'Replacing the
shaving heads').
This is normal and
not dangerous
because all
electronics are
enclosed in a sealed
power unit inside the
shaver.