Philips Wet and dry Shaver S7000 Mode D'emploi page 21

2
1
3 Rinse the hair chamber and shaving head
holder under the tap with warm water.
4 Turn the retaining ring counter clockwise and lift
it off the shaving head.
Repeat this process for the other retaining rings.
Place them aside in a safe place.
5 Remove the shaving heads from the shaving
head holder. Each shaving head consists of a
cutter and guard.
Note: Do not clean more than one cutter and
guard at a time, since they are all matching sets.
If you accidentally put a cutter in the wrong
shaving guard, it may take several weeks before
optimal shaving performance is restored.
6 Clean the cutter and guard with warm water.
7 Shake off excess water.
8 Put the cutter back into the guard.
9 Place the shaving heads in the shaving head
holder.
10 Place the retaining ring on the shaving head.
21
English