SOUNDMASTER TR-40 Mode D'emploi page 4

Table des Matières

Publicité

LOCATION OF CONTROLS
1.
Speaker
2.
Volume control and Power ON/OFF
3.
Band selector switch
4.
Tuning knob
5.
Dial scale
POWER SUPPLY
1.
To operate the set on AC power, insert one end of the AC power cord into the AC socket
(8) on the unit and the other end into a convenient standard Ac outlet.
2.
To use batteries, insert 4 pieces of 1.5V D/R20/Mono size batteries into the battery
compartment (9) at the back of the unit, making sure that the battery is connected
correctly.
The battery supply will be switched off when the set is connected to the AC power.
SET OPERATION
1.
Switch on the set by rotating the Volume control/PowerON/OFF knob (2) counter
clock-wise. Adjust the volume to a comfortable listening level.
2.
Set the Band selector switch (3) to the desired radio band (FM or AM).
3.
Turn the tuning knob (4) until the desired station is heard.
4.
To turn off the radio , rotate the knob (2) clockwise until a slight click is heard.
TELESCOPIC ANTENNA
1.
For FM reception, extend the telescopic rod antenna (6) to its full length, adjust the
direction and angle for best reception.
2.
For AM reception , the unit is incorporated with a built-in ferrite bar antenna.
Since the ferrite bar antenna is directional, rotate the set and position it for best Am
reception.
PHONE JACK
For private listening,connect the earphone or headphone with 3.5mm plug to the phone jack
(7). The built-in speaker is automatically disconnected.
SPECIFICATIONS
Frequency range:
Antenna:
Speaker:
Output power:
Phone jack:
Dimension:
Power sources:
R168-soundmaster-8LANG 105x148.i4 4
6.
Telescopic antenna
7.
Phone jack
8.
Ac socket
9.
Battery compartment
10. Handle
FM 87.5 - 108 MHz
AM 540 - 1600 kHz
FM - Telescopic rod antenna
Am - Built-in ferrite bar antenna
3 inch 8 Ohm dynamic speaker
1 Watt R.M.S.
3.5 mm
250(L) x 62(W) x 150(H) mm
DC 6V 4 x D/R20/Mono size
AC 230V ~ 50 Hz
E -2
2010/4/16
03:50:32

Publicité

Table des Matières
loading

Table des Matières