Pausing The Appliance - Inventum IMC3834GT Manuel D'utilisation

USING THE DEFROST PROGRAMS
Note:
• Only use frozen food stored at -18°C. Make sure that you freeze food in portions and as flat as
possible to fasten the defrosting process.
• Remove the packaging and weigh the defrosted food. You need to set the weight for the defrost
programs.
• Liquid can be produced during defrosting meat and poultry. Drain the liquid when you turn the food.
Make sure that the liquid does not come into contact with other food.
• Place the food on the glass baking tray or in a dish that is suitable for a microwave oven.
• After defrosting, leave the food to rest for 10 to 30 minutes to make sure that the complete dish has
the same temperature. Large pieces of meat require more time.
Defrosting by weight
1. Push the function button three times. The display shows '0.1 kg'.
2. Move the slider or push the up/down button to select the weight. The weight should be within 100 - 2000 grams.
3. Push the start button to start the appliance.
When the defrost program finishes, you will hear a sound signal and the appliance goes into standby.
Defrosting by time
1. Push the function button four times. The display shows '1:00'.
2. Move the slider or push the up/down button to set the time.
3. Push the start button to start the appliance.
When the defrost program finishes, you will hear a sound signal and the appliance goes into standby.
Note:
If half the defrosting time passed, a buzzer sounds two times. For a better defrosting result, you should
turn the food over. Close the door and push the start button again to continue the defrosting.
USING THE AUTOMATIC PROGRAMS
When using the automatic programs you only have to select a program and set the weight. The microwave power,
the time and the temperature are preset.
For an overview of the available automatic programs, refer to section
1. Push the auto menu button. The display shows the first automatic program number (A-1).
2. Push the auto menu button repeatedly to select an automatic program. The display shows the selected program,
the cooking time and the weight.
3. Move the slider or push the up/down button to select the weight.
4. Push the start button to start the appliance.
When the automatic program finishes, you will hear a sound signal and the appliance goes into the standby state.
Note:
• Once you selected an automatic program you cannot change it.
• You cannot change the cooking time.
• Some automatic programs use preheating. Note: Wait until the appliance is preheated, before placing
the food inside.
Note:
If you open the door of the appliance during cooking, you must touch the start/pause button to continue
the cooking.

PAUSING THE APPLIANCE

1. Push the cancel button to pause the program.
2. Push the start button again to start the appliance again.
'Auto menus' .
English • 35