Arktic 233689 Mode D'emploi page 6

Masquer les pouces Voir aussi pour 233689:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32
Preparation before using for the first time
• Remove all protective packaging and wrapping.
• Check for the completeness of the product. In
case of incomplete delivery and damages. Please
contact supplier (See == > Warranty).
• Clean all components as described (See ==>
Cleaning and Maintenance).
• This appliance can have capacity of up to 8 x 1/6
GN stainless steel containers. (Stainless steel
containers not supplied).
Operation
• Connect the power plug to a suitable electrical
power outlet.
• Switch ON the power switch and power indicator
will light up.
EN
• Digital temperature controller (at the front of the
appliance) operation
1) Setting the temperature
- Press SET to enter into the setting mode. The
set temperature is displayed.
- Press
or
temperature.
- Press SET again to confirm the setting and exit.
Then, inside cabinet temperature is displayed.
Note:
- If no button is pressed within 10 seconds. The
newly set temperature will be stored.
- The temperature setting range from -18°C to
-26°C. And the cabinet temperature range can
be kept from -18°C to -25°C.
- Keep the door open time as short as possible in
order to keep a cool temperature inside.
6
to increase or decrease the set
Note: Due to manufacturing residues, the appli-
ance may emit a slight odor in the first few cycles.
This is normal and does not indicate any defect or
hazard. Make sure the appliance is well ventilated.
• Leaving the appliance for running some hours to
reach the cooling temperature before placing the
beverage or food inside the appliance.
C
SET
2) Defrost function
- Press and hold the
onds to start/stop defrost.
3) Refrigerant LED indicator
- During the cooling operation (compressor en-
abled), this refrigerant LED indicator will lights
up constantly.
- After the inside cabinet reach the set tempera-
ture, the refrigerant LED indicator will flashes
continuously.
- When defrost start, the refrigerant LED indica-
tor light off.
4) Defrost LED indicator
- During the defrost operation, this defrost LED
indicator will lights up constantly.
- After the defrost operation, defrost LED indica-
tor will lights off.
button for about 6 sec-

Publicité

Table des Matières
loading

Table des Matières