Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• Do not make any additional openings on the appliance. Do not install any gadgets in the
appliance.
• Do not attempt to climb up to the top of the appliance.
Installing the appliance
• The appliance should not be tipped over an angle
of 45°. After installing the appliance, wait for 2
hours before connect to the electrical power sup-
ply to switch on. The same applies if the appli-
ance is moved at a later date.
• The appliance must always be installed in a dry
environment.
Electrical components and other dangers
• No other appliances should be plugged into the
same socket as with this appliance.
• Do not place any dangerous products, such as
fuel, alcohol, paint, flammable or explosives, etc.
inside or near the appliance as it may result a
fire hazard.
• Do not store any medications in the appliance.
Grounding installation
This appliance is classified as protection class I
appliance and must be connected to a protective
ground. Grounding reduces the risk of electric
shock by providing an escape wire for the electric
Different operation parts
• When installing, leave at least 10 cm clearance
to the rear and to the left and right for adequate
ventilation. Leaving less room for ventilation may
affect the efficiency.
• We strongly recommend to install the appliance
in a place with good natural ventilation to in-
crease ventilation properties.
• Wait about 5 minutes before switch on the appli-
ance again after the appliance has been switched
off or unplugged from the electrical power sup-
ply.
• Do not wash the appliance with water. Washing
can cause leakage and increase the risk of elec-
tric shock. No any parts/accessories can be un-
der dishwasher.
current. This appliance is equipped with a cord
having a grounding wire with a grounding plug. The
plug must be plugged into an outlet that is properly
installed and grounded.
EN
5
Publicité
Table des Matières
