Nolan N30 Sécurité Et Instructions D'utilisation page 8

INSTRUCTIONS FOR USE
This helmet is available in two configurations as shown in the figure 1 and 2 (only for
versions with padding) .
ATTENTION!!!
Use the helmet ONLY in one of the patterns shown.
• VISOR
1 Disassembly (Fig. 3)
1.1 With closed visor, unfasten the plate A by pulling towards the outside of the
helmet, and by holding the upper hollow part.
1.2 Repeat this step for the other side of the helmet and remove the visor C, also
paying attention not to lose the mechanism B.
2 Assembly (Fig. 3)
2.1 Put the visor together with mechanism B in the helmet seat, taking care of cor-
rectly positioning the fastening reference points (holes).
2.2 Hook the plate A ensuring that the reference tooth is correctly positioned and
pressing towards the helmet.
2.3 Repeat this step on the other side of the helmet.
ATTENTION!!!
- Make sure that the mechanism operates properly by pulling up and down the
visor.
- The helmet should always be used with all of its components correctly assem-
bled. Should any of the components be malfunctioning or damaged, please refer
to a Nolan authorized dealer.
• ROLL NECK PADDING
(only for versions with padding)
1 Disassembly
1.1 Undo the chin strap.
1.2 Pull out the chin strap ends from the loops in the roll neck padding.
1.3 Open the zip and remove the roll neck.
1.4 After removing the roll neck, it is necessary to check that the chin strap is adjusted
correctly. (see attached label)
2 Assembly
2.1 Undo the chin strap.
2.2 Insert the roll neck, fasten it and close the zip.
2.3 Insert both ends of the chin strap in the specific loops on the roll neck padding.
2.5 Before using the helmet, make sure that the sliding clip of the zip does not pro-
trude from the helmet itself and that it is correctly bent and folded between the roll
neck padding and the chin strap.
2.6 After assembling the roll neck, it is necessary to check that it is adjusted correctly.
8