Electrical Installation Instructions (240V) - N.P.I. Impulse Manuel Du Propriétaire

ELECTRICAL INSTALLATION INSTRUCTIONS continued
4. A suitable ground fault circuit interrupter (GFCI) as required by
the local building/electrical inspection authority, must be
included in the electrical circuit supplied to the hot tub.
5. Proper wire size must be used in accordance to the local
building/electrical inspection authority.
6. All wires must be securely hooked up or damage could result.
TIGHTEN SECURELY!
WARNING: DO NOT CONNECT ELECTRICAL UNTIL TUB IS
FILLED COMPLETELY WITH WATER!
Convertible Tubs (Americas Only – Sport, Insider, Crown II,
Warrior XL and Escape)
To convert the Hot Tub from 120 volt to 240 volt, please move
jumper 1 from Position 2 into Position 1 (HC Mode). Jumper 1
on the PC Board is used to limit the current draw when
connected to 120 volts.
Position 1 (HC Mode):
The system allows the heater to turn on when the pump is on
high speed.
Position 2 (LC Mode) – Mandatory for 120 volt systems: The
system will not turn the heater on when the pump is on high
Move Top Pin Jumper Only when
converting from 120v to 240v.
JUMPER SETTINGS
JUMP1 – HC MODE
JUMP2 – °F UNITS
JUMP3 – SINGLE PUMP
Pin Jumpers
– LC MODE
– °C UNITS
– DUAL PUMP
120V Service
1. This tub requires that the power supply be on a dedicated
circuit with no other electrical appliances or lights sharing the
circuit that is providing power to the hot tub.
2. Do not use aluminum wiring. ALL WIRING MUST BE
COPPER.
3. A suitable ground fault circuit interrupter (GFCI) as required by
the local building/electrical inspection authority, must be
included in the electrical circuit supplied to the hot tub.
4. Proper wire size must be used in accordance by the local
building/electrical inspection authority.
WARNING: DO NOT CONNECT ELECTRICAL UNTIL TUB IS
FILLED COMPLETELY WITH WATER!
speed. The "Heater On" indicator will flash on the display to
show there is a call for heat, but that the heater is not allowed
to start.
See picture below for locating jumpers.
NOTE: The Rendezvous, Escape Premium, Crown and Crown
XL are 240 volts only and can not be converted to 120 volts.
Impulse tubs are 120 volt only and cannot be converted to
240 volts.
All European (CE) tubs are 230 volt only and the above does
not apply.
4