Technical Data - Gardena 9000 aquasensor Mode D'emploi

1783-20.960.06_18.08.2011_GARDENA.qxp 06.09.2011 12:03 Seite 17
Problem
Pump is running,
but doesn't deliver
The pump does not switch
on or off. Pump switches off
although the OFF sensor is
in the water
Pump doesn't start or
suddenly stops during
operation
Pump runs, but output
suddenly decreases
In the event of other faults please contact GARDENA Service.
Repairs should only be carried out by GARDENA service centres or dealers
A
authorised by GARDENA.

8. Technical Data

Type
Rated power
Max. delivery capacity
Max. pressure
Max. delivery height
Max. submersion depth
Residual water level
Contaminated water with
particle size of max.
Power cable
Pump connection
Min. water level for operation
Weight approx. (without cable)
Max. media temperature
Mains voltage /
mains frequency
Probable cause
When starting the pump,
water height falls below the
min. water level.
3 4
Sensors / and contacts
are dirty.
Thermal overload switch has
switched the pump off due
to overheating.
No power.
Dirt particles are jammed
in the suction base.
Suction base is clogged.
Submersible pumps
aquasensor
9000 13000
(Art. 1783) (Art. 1785)
320 W 650 W
9,000 l / h 13,000 l / h
0.7 bar 0.8 bar
7 m 8 m
7 m 7 m
1 mm 1 mm
5 mm 5 mm
10 m H05 RNF 10 m H07 RNF 10 m H05 RNF
universal (G 1 ¹⁄₄ " M) / universal nipple
5 mm 5 mm
3.8 kg 5.4 kg
35 °C 35 °C
230 V / 50 Hz 230 V / 50 Hz
Remedy
v Submerge pump deeper.
7
v Clean sensors (see
6. Maintenance).
v Disconnect plug and clean
impeller (see 6. Maintenance).
Observe max. media
temperature of 35 °C.
v Check fuses and electric
connections.
v Disconnect plug and clean
suction base (see
6. Maintenance).
v Disconnect plug and clean
suction base (see
6. Maintenance).
Dirty water pumps
aquasensor
8500 13000
(Art. 1797) (Art. 1799)
380 W 680 W
8,300 l / h 13,000 l / h
0.6 bar 0.9 bar
6 m 9 m
7 m 7 m
35 mm 35 mm
30 mm 30 mm
10 m H07 RNF
45 mm 45 mm
4.0 kg 5.6 kg
35 °C 35 °C
230 V / 50 Hz 230 V / 50 Hz
17