Iberspa 43639 Manuel D'utilisation page 17

tape. Under no circumstance should you use metal accessories or tubing, which
could seriously damage the plastic components.
Connection between Spa – Compact Kit
If your spa has a spa floor cleaning connection; connect the floor cleaning outlet
with the filter pump inlet making the connection in parallel with the other inlets to
this pump. You must place a ball valve between the outlet and the pump which will
normally remain closed.
• Option A Spa Floor Suction: Connect the Spa floor drain to an inlet in parallel to the
filter pump. Place a ball or guillotine valve between this connections.
• Option B Spa Floor Return: No operation is required.
Connection between Compact Kit – Spa
Connect the heat exchanger with the Spa filter return sleeves.
• Option A Spa Floor Suction: Place a check valve between the exchanger outlet and
the inlet to the spa.
• Option B Spa Floor Return: Connect the exchanger outlet with the Spa floor drain,
in parallel with the filter return via the return nozzles.
Installation of level sensors
In order to ensure that the recirculating circuit always contains water, you must install
the level senors in the balance tank. These will control the opening and closing of a
filling solenoid valve.
Look at the following diagram.
S
MAX
S
MIN
S
0
5
cm min
Electrical board.
Connector M5
EV
5
cm min
Electrical board.
Connector M9
2 3 4 5
WHITE GREEN (1,2,3)
(Smax) 2(Smin) 3(S0)
WHITE 1
GREEN 1
BROWN 1
WHITE 2
GREEN 2
BROWN 2
WHITE 3
GREEN 3
BROWN 3
ENG
6
BROWN (1,2,3)
123
17