Electrolux S163TK48 Mode D'emploi page 16

16 Installation
3. Unscrew both adjustable feet.
4. Unscrew the screws of the door bottom
hinge. Remove the hinge. Put over the
pin in the direction of the arrow.
5. Unscrew and install the screw on the
opposite side.
6. Install the hinge on the opposite side.
7. Remove the door by pulling it down-
wards while keeping it slightly opened.
8. Unscrew the upper door hinge, and
screw it in on the opposite side.
9. Put the door back in its place.
10. Relocate the door holder pin in the door
hinge as per the figure.
11. Place the door holder pin in the door at
the bottom on the left side, and fix the
door hinge with the screw.
12. Screw both adjustable feet.
13. Raise the appliance in the upright position.
14. Remove and install the handle
opposite side.
15. Reposition, level the appliance, wait for
at least four hours and then connect it
to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natural
fitting of the gasket.
In case you do not want to carry out the above mentioned operations, contact the nearest
After Sales Service Force. The After Sales Service specialist will carry out the reversibility of
the doors at your cost.
4) If foreseen
All manuals and user guides at all-guides.com
4)
on the