Beta RR 400 Mode D'emploi page 115

3
CHANGING THE ENGINE OIL AND THE
OIL FILTER
Before performing this operation, if lower
bumper A is present, remove it after un-
screwing the three screws B as shown in
the figure.
Whenever the oil is changed, the long and
short oil units need to be cleaned and both
B
A
oil filters replaced.
The oil must be changed when the engine
is at operating temperature.
WARNING
When at operating temperature, the en-
gine and the oil it contains are very hot.
Take special care to avoid burns.
Park the motorcycle on level ground, re-
move screw C and let the oil drain in a
container.
B
Thoroughly clean the screw (with a mag-
net). After the oil has drained completely,
clean the sealing surface, replace screw
C with the seal ring and tighten at 20 Nm.
C
GB
37