Elica NIKOLA TESLA SWITCH Emploi Et Entretien page 13

• Safety Shut Down: For safety reasons, each cooking zone
has a maximum operating time, which depends on the
maximum power level set.
• Residual Heat Indicator: When switching off one or more
cooking zones, the residual heat is indicated with a specific
visual signal on the display of the corresponding zone by the
" " symbol.
3.2.4 Operation
Note: activate the required zone first
• Switching on: touch
touch again to switch off.
• Cooking Zone Selection
the selection bar (3) corresponding with the desired cooking
zone.
• Power Level
Touch the selection bar (3) and slide right with fingers to
increase the Power Level, left to decrease.
There are 9 power levels available + an intensive power level
indicated on the display by the " " symbol (Power Booster).
The " " power level (Power Booster) remains active for 5
minutes, after which the power returns to the previous level.
• Bridge Zones: Cooking Zones FL
("Secondary") and the zones FR
RR ("Secondary") can work as a pair or in combined
mode creating a single zone thanks to the Bridge function (2 in
total: 1 on the right and 1 on the left) with the same power level.
This function allows evenly distributed cooking with large-sized
pots and pans.
To activate the Bridge Function:
- select both cooking zones to be used simultaneously
- The Bridge indicator
zone lights up
- using the Selection area (3), of the "Master" cooking zone
the Operating power level can be set
- to disable the Bridge Function all you have to do is to
repeat the activation procedure
• Power Limitation
The Power Limitation function allows for operation of the product
to be set to limit the power consumption (kW)
Note : the setting of the hob must be made with the hob
switched off at the time it is connected to the electrical supply, or
when reconnected to the electrical supply, within 2 minutes,
without pressing the
To set the Power Limitation:
- touch and hold the
ON/OFF hob/ extractor system.
("Master") and RL
("Master") and
(21) of the "Secondary" cooking
button.
buttons until you hear a brief
acoustic signal.
- slide simultaneously on the FL and RL selection bars
then press and hold the corresponding area at the last power
level
- the Timer (15) display shows the symbols "CF6", to indicate
that it is possible to run the setup
- then press the
display PHA (Phase Power Limit):
−
: Touch
−
- to change the Power Limitation settings, slide on the
selection areas FL
. to save the selection made, press the
second; an audible signal will be emitted to confirm the setting
and the function quits.
3.3 Using the extractor system
• Switching on: Touch
system.
Touch again to switch off.
• Switching the extractor system off: Open the Flap ttouch
the Selection bar (6) to activate the extractor system.
Note: The extractor zone is fitted with a mechanical rotating
FLAP. The FLAP must be opened before switching on the
hood to activate the extractor system. The hood has a sensor
which when the extractor is on stops the motor automatically if
the FLAP is closed. Extraction only starts again when the
FLAP is reopened.
• Extraction speed (power):
Touch and slide your fingers along the Selection bar (6):
to the right to increase extraction speed (power) (0-8);
to the left to decrease extraction speed (power) (8-0).
The product has an additional 2 timed extraction speeds
(power levels):
"9" for 15 minutes,
"10" for 5 minutes
after that the power returns to level 8
Note: both speeds are indicated on the display (13) of the
selected cooking zone with the " " symbol.
13
, from left to right,
until a brief acoustic signal is emitted
button and the display timer (15) will
the FL zone display shows the current
setting**
0 = 7.4 KW (default setting)
1 = 4.5 KW
2 = 3.1 KW
ON/OFF of the hob/extractor
buttons for 1