Removing The Sun Shroud; Reinstalling The Sun Shroud - Avigilon 1.0W-H3-BO1-IR Guide D'installation

Removing the Sun Shroud

The sun shroud is not required when the camera is installed indoors.
1. As you press down on the center of the sun shroud, pull up
the corners of the shroud from one side of the camera.
Avoid the black tab on the sun shroud mount.
The sun shroud should lift off the camera.
2. Use a 2 mm or 5/64" hex driver to unscrew and remove the
sun shroud mount from the camera.

Reinstalling the Sun Shroud

1. Use a 2 mm or 5/64" hex driver to screw on the sun shroud
mount.
2. Align one side of the sun shroud on to the mount.
3. Press down on the center of the sun shroud until it clicks
into place.
11