Installation; Camera Package Contents; Installation Steps; Adding The Mounting Holes - Avigilon 1.0W-H3-BO1-IR Guide D'installation

Installation

Camera Package Contents

Ensure the package contains the following:
• Avigilon High Definition IP Bullet Camera
• T20 TORX tamper resistant key
• 4 screws and anchors for solid walls
• Drill template sticker
• Configuration Panel opening tool

Installation Steps

Complete the following procedures to install the camera.
1. Adding the Mounting Holes on page 4
2. Connecting Cables on page 5
3. Mounting the Camera on page 5
4. Assigning an IP Address on page 6
5. Accessing the Live Video Stream on page 6
6. Aiming the Camera on page 7
7. Focusing the Camera on page 8

Adding the Mounting Holes

1. Use the drill template to drill four mounting holes in the
ceiling or wall.
•
4
Only drill the optional center hole if you are flush
mounting the camera. Once the center cable hole
has been drilled, pull the required cables through.