Aiming The Camera - Avigilon 1.0W-H3-BO1-IR Guide D'installation

• (Recommended) Avigilon Camera Installation Tool
software application.
• Camera's web browser interface:
http://<camera IP address>/.
• Network Video Management software application (for
example, Avigilon Control Center).
NOTE: The default camera username is admin and the default
password is admin.

Aiming the Camera

1. (Optional) To help you aim the camera, you can connect
an Ethernet cable to the secondary Ethernet port in the
Configuration Panel.
Be aware that while the Configuration Ethernet Port is in
use, the primary Ethernet port at the back of the camera
will only be used for PoE.
Important: While the Configuration Ethernet Port is in use, the
camera will only stream video and accept commands from the
Configuration Ethernet Port. Also, the Indicator LEDs will only show
the connection status for this Ethernet port.
2. To aim the camera, loosen the adjustment screws on the
camera mount arm.
Only loosen the screws that can be rotated by the supplied
tamper resistant key.
3. Rotate and move the camera and mount arm as required.
Review the camera's live video stream to help aim the
camera correctly.
4. Slide the sun shroud forward or back to protect the camera
against glare from the sun. In outdoor installations, the sun
shroud should be set as far forward as possible without
intruding on the video image.
• To move the sun shroud, hold down the black tabs
on either side of the camera then slide the sun
shroud forward or back.
7