Reset To Factory Default Settings - Avigilon 1.0W-H3-BO1-IR Guide D'installation

Reset to Factory Default
Settings
If the camera no longer functions as expected, you can choose to
restore the camera to its factory default settings.
Use the firmware revert button to reset the camera.
Figure: The firmware revert microswitch in the Configuration Panel.
1. Ensure the camera is powered on.
2. Unscrew the Configuration Panel Plug at the bottom of the
camera with the supplied opening tool.
3. Using a straightened paperclip or similar tool, gently press
and hold the firmware revert microswitch for 2 seconds.
4. Screw the Configuration Panel Plug back into place.
Caution — Do not apply excessive force. Inserting the tool
too far will damage the device.
12
Firmware Revert Button