Invacare Matrx Libra Manuel De Réparation page 3

Press down to secure the abductor support F to the foam
3.
cushion B.
4. Re-install the inner liner and outer cover.
3.4 Installing the Fluid Supplement
1. Remove outer cover and inner liner and unfasten the hook and
loop strips from the side and/or rear of the fluid sac C where you
wish to install the fluid supplement pack(s) G.
2. Locate the small pocket/slot O on the underside of the fluid
sac C.
Install the fluid supplement pack(s) G inside the slot/pocket and
3.
adjust the fluid supplement pack to the desired position inside
the fluid sac.
4. Refasten the fluid sac hook and loop strips and re-install the inner
liner and outer cover.
1190579-A-02
3.5 Installing a Seat Wedge, Lateral Wedge
and/or Tapered Wedge
Foam wedges can be trimmed as needed to fit the cushion
dimensions and/or the cushion contours.
Lateral wedges are sold individually.
1. Remove the outer cover and inner liner and position the wedge(s)
in the desired position on the underside of the foam cushion B
as shown:
Seat Wedge (H), Hemi Wedge (I)
For Hemi Wedge installation I, disengage the front
fluid sac attachment and carefully cut the cushion foam
along the mid-line of the cushion back to the slot for
the fluid sac attachment..
Lateral Wedge (J)
RF/LR Tapered Wedge (K) and LF/RR Tapered Wedge
(not shown)
2. Using the hook and loop strips, secure wedge(s) to the underside
of the foam cushion.
3. Re-install the inner liner and outer cover.
3