St3100M Ph Operation; Setup; Set Temperature Unit And Mtc Value - OHAUS STARTER 3100M Manuel D'instruction

STARTER 3100M Bench Meter
3

ST3100M pH Operation

WARNING Do not operate the equipment in hazardous environments. The
equipment is not explosion protected.
WARNING When using chemicals and solvents, comply with the instructions of the
chemical producer and the general lab safety rules.
3.1

Setup

3.1.1

Set temperature unit and MTC value

Please note:
If a temperature electrode is used, Automatic Temperature Compensation (ATC) and the sample
temperature are displayed on the screen. You may then choose to skip MTC setup (below).
If the meter does not detect a temperature electrode or one is not used, the meter automatically switches to
Manual Temperature Compensation (MTC) mode and MTC appears on the screen.
MTC can be set as follows:
 Power on the meter by pressing
 Press and hold
temperature unit blinks (°C or °F).
 Press or
 Press
Then
 Continue with MTC temperature setting by using
compensation accordingly
 Press
 Press
The default MTC temperature value setting is 25 ° C (77°F).
°C = 5/9 (°F - 32)
Note:
Note: STARTER 3100M accepts NTC 30 kΩ temperature sensor.
until the setup icon
to switch between °C and °F .
to confirm your selection.
to confirm the setting
to return to the measurement screen.
.
appears on the display and the current
or
EN 9
-
to adjust temperature