Changing The Admin Pin - iStorage DISKASHUR M2 Manuel De L'utilisateur

6. Changing the Admin PIN

PIN Requirements:
• Must be between 7-15 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7), (7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
Password Tip:
You can configure a memorable word, name, phrase or any other Alphanumerical PIN combination
by simply pressing the button with the corresponding letters on it.
Examples of these types of Alphanumerical PINs are:
• For "Password" press the following buttons:
7 (pqrs) 2 (abc) 7 (pqrs) 7 (pqrs) 9 (wxyz) 6 (mno) 7 (pqrs) 3 (def)
• For "iStorage" press the following buttons:
4 (ghi) 7 (pqrs) 8 (tuv) 6 (mno) 7 (pqrs) 2 (abc) 4 (ghi) 3 (def)
Using this method, long and easy to remember PINs can be configured.
To change the Admin PIN, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode
(solid BLUE LED) proceed with the following steps.
1. In Admin mode press and hold down both
the KEY ( ) + 2 buttons
2. Enter NEW Admin PIN and then press the
KEY ( ) button once
3. Re-enter the NEW Admin PIN and then press the
KEY ( ) button once
Note: To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
BLUE LED), press and hold down the SHIFT ( ) button for a second - the
RED LED.
www.istorage-uk.com
Solid BLUE LED will change to blinking
solid BLUE LEDs
Blinking GREEN and solid BLUE
a single GREEN LED blink and then back to blinking
GREEN and solid BLUE LEDs
Blinking GREEN and solid BLUE
a rapidly blinking BLUE LED and finally to a solid
BLUE LED indicating the Admin PIN has been
successfully changed
GREEN and
LEDs will switch to
LEDs change to
#9