How To Configure An Admin Pin After A Brute Force Attack Or Reset; Setting The Unattended Auto-Lock - iStorage DISKASHUR M2 Manuel De L'utilisateur

25. How to Configure an Admin PIN after a Brute Force attack or Reset

It will be necessary after a Brute Force attack or when the diskAshur M
used.
PIN Requirements:
• Must be between 7-15 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7), (7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
If the diskAshur M has been brute forced or reset, the drive will be in standby state (solid
2
proceed with the following steps.
1. In Standby state (solid RED
down both SHIFT ( ) + 1 buttons
2. Enter New Admin PIN and press KEY ( )
button
3. Re-enter the New Admin PIN and press
KEY ( ) button
Note: To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid

26. Setting the Unattended Auto-Lock

To protect against unauthorised access if the drive is unlocked and unattended, the diskAshur M
automatically lock after a pre-set amount of time. In its default state, the diskAshur M
feature is turned off. The Unattended Auto Lock can be set to activate between 5 - 99 minutes.
#20
LED), press and hold
BLUE LED), press and hold down the SHIFT ( ) button for a second - the
RED LED.
www.istorage-uk.com
has been reset to configure an Admin PIN before the drive can be
2
RED LED). to configure an Admin PIN
Solid RED LED will change to blinking
solid BLUE LEDs
Blinking GREEN and solid
a single GREEN LED blink and then back to blinking
GREEN and solid
Blinking GREEN LED and solid
to BLUE LED rapidly blinking for a few seconds and
then to a solid BLUE
was successfully configured.
can be set to
2
Unattended Auto Lock time-out
2
GREEN and
BLUE LEDs will switch to
BLUE LEDs
BLUE LED change
LED indicating the Admin PIN