Enable Global Read/Write In Admin Mode; How To Configure A Self-Destruct Pin - iStorage DISKASHUR M2 Manuel De L'utilisateur

21. Enable Global Read/Write in Admin Mode

To set the diskAshur M back to Read/Write from the Global Read-Only setting, first enter the "Admin Mode" as described in section 5.
2
Once the drive is in Admin Mode (solid
1. In Admin mode, press and hold down both "5 + 9"
buttons.
2. Press KEY ( ) button
Note: To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid

22. How to configure a Self-Destruct PIN

You can configure a self-destruct PIN which when entered performs a Crypto-Erase on the drive (encryption key is deleted).This process
deletes all configured PINs and renders all data stored on the drive as inaccessible (lost forever), the drive will then show as unlocked
GREEN LED. Running this feature will cause the self-destruct PIN to become the New User PIN and the drive will need to be formatted
before it can be reused.
To set the Self-Destruct PIN, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode (solid
LED) proceed with the following steps.
1. In Admin mode, press and hold down both
KEY ( ) + 6 buttons
2. Configure and enter a 7-15 digit Self-Destruct PIN and
press the KEY ( ) button
3. Re-enter your Self-Destruct PIN and press
the KEY ( ) button
Note: To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
#18
BLUE LED) proceed with the following steps.
BLUE LED), press and hold down the SHIFT ( ) button for a second - the
RED LED.
BLUE LED), press and hold down the SHIFT ( ) button for a second - the
RED LED.
www.istorage-uk.com
Solid BLUE LED will change to blinking
BLUE LEDs
GREEN and BLUE LEDs change to a solid
LED then to a solid BLUE LED
indicating the drive is configured as Read/Write
Solid BLUE LED will change to blinking
solid BLUE LEDs
Blinking GREEN and solid BLUE
a single GREEN LED blink and then back to blinking
GREEN and solid BLUE LEDs
GREEN LED will rapidly blink for several
seconds and then changes to a solid
to indicate the Self-Destruct PIN has been
successfully configured
GREEN and
GREEN
BLUE
GREEN and
LEDs will switch to
BLUE LED