How To Check Firmware In User Mode - iStorage DISKASHUR M2 Manuel De L'utilisateur

44. How to check Firmware in User Mode

To check the firmware revision number, first enter the "User Mode" as described in section 13. Once the drive is in User Mode
(solid GREEN LED) proceed with the following steps.
1. In User mode press and hold down both "3 + 8"
buttons until GREEN and
2. Press the KEY ( ) button and the following happens;
a. All LED's (RED, GREEN
b. RED LED blinks indicating the integral part of the firmware revision number.
c. GREEN LED blinks indicating the fractional part.
d. BLUE LED blinks indicating the last digit of the firmware revision number
e. All LED's (RED, GREEN
f. RED, GREEN & BLUE LEDs switch to a solid
For example, if the firmware revision number is '2.3', the
Once the sequence has ended the RED,
LED.
#36
BLUE LEDs blink together
& BLUE) become solid for 1 second.
& BLUE) become solid for 1 second.
BLUE LED
GREEN & BLUE LED's will blink together once and then return to the User mode, a solid
Solid
and
RED LED will blink twice (2) and the
www.istorage-uk.com
GREEN LED will change to blinking
BLUE LEDs
GREEN LED will blink three (3) times.
GREEN
GREEN